Grand Voyager V6-201 3.3L VIN R SMFI (1997)
1. Connect the front wheel speed sensor cable to the vehicle wiring harness connector. Be sure speed sensor cable connector is fully seated and
locked into vehicle wiring harness connector, then insert cable and grommet into hole in strut tower.
CAUTION: When installing channel bracket, do not pinch the speed sensor cable under the channel bracket.
Front Speed Sensor Cable Channel Bracket
2. Install the channel bracket and grommet retainer on the frame rail.
3. Install the 2 bolts attaching the channel bracket to frame. Tighten the 2 attaching bolts to a torque of 11 Nm (95 inch lbs.).
4. Insert speed sensor cable grommets into intermediate bracket on strut. Route cable from strut to steering knuckle on the rearward side of the
stabilizer bar link.
Front Wheel Speed Sensor Attaching Bolt
