Grand Voyager V6-201 3.3L VIN R SMFI (1997)
6. Tighten the 4 hub/bearing mounting bolts to a torque of 129 Nm (95 ft. lbs.).
7. Install the rear wheel speed sensor on the rear hub/bearing flange. Install the speed sensor attaching bolt and tighten to a torque of 12 Nm (105
inch lbs.).
8. Check the air gap between the face of the wheel speed sensor and the top surface of the tonewheel. Air gap must be less then the maximum
allowable tolerance of 1.2 mm (.047 inch).
9. Install the brake drum onto the rear hub/bearing assembly.
10. Install rear wheel and tire assembly, tighten wheel stud nuts to 115-156 Nm (84-115 ft. lbs.).
11. Adjust the rear drum brake brakes.
