Grand Voyager V6-201 3.3L VIN R SMFI (1997)
Engine Mount: Service and Repair
Right Mount
NOTE: Right mount should only be serviced as an assembly to prevent noise, vibration and harshness concerns.
REMOVAL
1. Remove the purge duty solenoid and wiring harness from engine mount.
2. Remove the two right engine mount insulator vertical fasteners and loosen the horizontal fastener, Do Not remove the large nut on the end of the
core from frame rail.
3. Remove the load on the engine motor mounts by carefully supporting the engine and transmission assembly with a floor jack.
4. Remove the vertical and horizontal fasteners from the engine side bracket. Remove the engine mount assembly
INSTALLATION
1. Reverse removal procedure for installation. Tighten assembly in the following order:
a. Engine mount to rail fasteners to 68 Nm (50 ft. lbs.).
b. The vertical engine fastener to 102 Nm (75 ft. lbs.).
c. The horizontal fastener to 150 Nm (111 ft. lbs.).
2. Install the purge duty solenoid and wiring harness to the engine mount.
3. Engine mount adjustment.
