Grand Voyager V6-201 3.3L VIN R SMFI (1997)
Radiator Cooling Fan Motor Relay: Testing and Inspection
Fan control is accomplished two ways. A pressure transducer on the compressor discharge line sends a signal to the Powertrain Control Module
(PCM) which will activate the fan. In addition to this control, the fan is turned on by the temperature of the coolant which is sensed by the coolant
temperature sensor which sends the message to the PCM. The fan will not run during cranking until the engine starts no matter what the coolant
temperature is.
CAUTION: The solid state fan relay is attached to the left frame rail near the lower radiator support. The relay bracket, and fastener are used to
dissipate heat from the relay. Ensure the relay is properly attached to prevent the following:
-
Intermittent engine overheating.
-
Relay "thermal" shutdown, or relay damage.
For Diagnosis See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Manufacturer Code Charts/Trouble Code (TC) Tests/TC-14A RAD Fan Control Relay Circuit
