Grand Voyager V6-201 3.3L VIN R SMFI (1997)
6. Remove the 2 strut assembly clevis bracket to steering knuckle attaching bolts.
7. Remove the 3 nuts attaching the strut assembly upper mount to the strut tower.
Installation
1. Install strut assembly into strut tower, aligning and installing the 3 studs on the upper strut mount into the holes in shock tower. Install the 3 upper
strut mount attaching nut/washer assemblies. Then using a crow foot. tighten the 3 attaching nuts to a torque of 28 Nm (250 inch lbs.).
CAUTION: The steering knuckle to strut assembly attaching bolts are serrated and must not be turned during installation. Install nuts while holding
bolts stationary in the steering knuckles.
