Grand Voyager V6-201 3.3L VIN R SMFI (1997)
Wiper Gear Box: Service and Repair
Wiper Unit Wire Connector
REMOVAL
1. Remove the wiper arms.
2. Remove the cowl cover.
3. Release the hood latch and open hood.
4. Disconnect the positive lock on the wiper unit wire connector.
5. Disconnect the wiper unit wire connector from the engine compartment wire harness.
6. Disconnect the windshield washer hose from coupling inside unit.
7. Disconnect the drain tubes from nipples on bottom of the wiper unit.
8. Remove nuts holding wiper unit to lower windshield fence.
Wiper Unit
9. Remove bolts holding the wiper unit to the dash panel.
10. Lift wiper unit from weld-studs on lower windshield fence.
CAUTION: Do not allow wiper unit to rest on brake master cylinder reservoir, damage to brake system can result.
11. Remove wiper unit.
INSTALLATION
1. Install wiper unit.
2. Lower wiper unit from weld-studs on lower windshield fence.
CAUTION: Do not allow wiper unit to rest on brake master cylinder reservoir, damage to brake system can result.
3. Install bolts holding the wiper unit to the dash panel.
4. Install nuts holding wiper unit to lower windshield fence.
5. Connect the drain tubes from nipples on bottom of the wiper unit.
6. Connect the windshield washer hose from coupling inside unit.
7. Connect the wiper unit wire connector from the engine compartment wire harness.
8. Connect the positive lock on the wiper unit wire connector.