Grand Voyager V6-229 3.8L (1996)
INSTALLATION
1. Lower front corner of suspension cradle until pivot bolt will clear transaxle, then install pivot bolt in front suspension cradle and lower control
arm.
2. Install two suspension cradle to body mounting bolts.
Fig. 17 Rear Bushing Retainer Installation
3. Install rear bushing retainer of lower control arm to front suspension cradle.
Raised rib on bushing must be positioned into groove on retainer.
4. Install lower control arm ball joint stud to knuckle and tighten to specification.
5. Install cradle plate on front suspension cradle and tighten mounting bolt to specification.
6. Place a suitable jack under control arms as close to ball joint as possible, then lower vehicle until full weight is supported by jacks.
7. Tighten front lower control arm pivot bolt, then the rear lower control arm bushing retainer to specifications.
8. Install wheel and tire assembly.
