Grand Voyager V6-229 3.8L (1996)
Fig. 22 Cage & Cross Installed In Housing
When properly assembled, large counterbore in cross should be facing outward from joint on G.K.N. joint.
Fig. 23 Cage & Cross Assembled
On S.S.G. joint, internal clip in cross will be facing outward from housing.
5. Apply suitable lubricant to ball races between all sides of ball grooves.
6. Insert balls into raceway by tilting cage and inner race assembly.
7. Slide small end of boot over shaft, then place clamp over groove on boot.
