Grand Voyager V6-3.0L VIN 3 (1998)
Rear Speed Sensor Routing Brackets And Clips
6. Remove the 2 rear wheel speed sensor cable/ brake tube routing clips. Then un-clip the speed sensor cable from the routing clips on rear brake
tube.
CAUTION: If the speed sensor has seized, due to corrosion, do not use pliers on speed sensor head in a attempt to remove it. Use a hammer and
a punch and tap edge of sensor, rocking the sensor from side to side until free.
Rear Wheel Speed Sensor Attaching Bolt
7. Remove the wheel speed sensor head to rear bearing attaching bolt. If sensor head does not come loose, do not use pliers. Tap with screw driver
and hammer.
8. Remove the wheel speed sensor head from the rear bearing assembly.
9. Remove speed sensor assembly from vehicle.
INSTALL
CAUTION: Proper installation of wheel speed sensor cables is critical to continued system operation. Be sure that cables are installed in retainers.
Failure to install cables in retainers as in this section may result in contact with moving parts and/or over extension of cables, resulting in an open
circuit.
1. Install wheel speed sensor head. Note, the plastic anti rotation pin must be fully seated prior to installing the attaching bolt.
CAUTION: Prior to installing the speed sensor head attaching bolt, the plastic anti-rotation pin must be fully seated into the bearing flange.
2. Install the wheel speed sensor head to bearing Range attaching bolt. Tighten the attaching bolt to a torque 12 Nm (105 inch lbs.).
3. Check the air gap between the face of the wheel speed sensor and the top surface of the tonewheel. Air gap must be less then the maximum
allowable tolerance of 1.2 mm (0.047 inch).
4. Install the 2 routing brackets attaching the speed sensor cable and brake tube to the rear axle. The rear wheel speed sensor cable should be routed
under the rear brake tube.
CAUTION: When installing rear wheel speed sensor cable in the routing clips on rear brake flex hose, be sure not to damage the routing clips.
Routing clips are molded onto the hose and will require replacement of the brake flex hose if damaged during installation of the wheel speed
sensor cable.
