Grand Voyager V6-3.0L VIN 3 (1998)
Removing Caliper Guide Pin Bolts
3. Remove the disc brake caliper to adapter guide pin bolts.
Removing/Installing Caliper
4. Remove rear caliper from adapter using the following procedure. First rotate rear of caliper up from the adapter. Then pull the front of the caliper
and the outboard brake shoe anti-rattle clip out from under the front abutment on the adapter.
Correctly Supported Caliper
5. Support caliper to prevent the weight of the caliper from damaging the flexible brake hose.
INSTALL
NOTE: Step 1 below is only required when installing the disc brake caliper after new brake shoes have been installed.
1. Completely retract caliper piston back into piston bore of caliper assembly.
2. Lubricate both adapter abutments with a liberal amount of Mopar Multipurpose Lubricant, or equivalent.
