Grand Voyager V6-3.0L VIN 3 (1998)
7. Install the serpentine drive belt. Refer to Engine.
8. Install the power steering fluid return hose on the steel tube at the front suspension cradle.
9. Install a screw type hose clamp on the power steering hose to steel tube connection. Tighten the screw clamp to a torque of 2 Nm (18 inch lbs.).
CAUTION: The protective heat shield sleeves must cover the entire rubber hose and hose to tube connection portion of both the power steering
fluid pressure and return hoses. This is required to prevent overheating of the power steering hoses.
10. When used, properly position the protective heat sleeves on the power steering hoses. Then, tie strap the heat sleeves to the power steering hoses
to keep them in their proper position.
11. Install the exhaust pipe on the exhaust manifold. Install all exhaust system hangers/isolators on the exhaust system brackets.
12. Connect the oxygen sensor wiring harness to the vehicle wiring harness. Install wiring harness grommet in the floor pan of the vehicle.
