Grand Voyager V6-3.0L VIN 3 (1998)
Suspension Strut / Shock Absorber: Service and Repair
Shock Absorber Replacement
REMOVAL/INSTALLATION
1. Raise vehicle. Vehicle is to be raised and supported on jackstands or on a frame contact type hoist.
2. Support the rear axle of the vehicle using 2 jackstands positioned at the outer ends of the axle.
NOTE: If the shock absorber lower mounting bolt deflects upward during removal, raise axle by adjusting the support jack. If the lower shock
absorber bolt deflects downward during removal, lower the axle by adjusting the support jack.
3. Remove the shock absorber lower mounting bolt.
4. While holding shock absorber, remove the shock absorber upper mounting bolt.
5. To install the shock absorber use the reverse sequence of its removal.
6. Lower the vehicle to the ground so the full weight of the vehicle is supported by the suspension.
7. Tighten the upper and lower shock absorber mounting bolt to their specified torques.
