Grand Voyager V6-3.0L VIN 3 (1998)
Shift Interlock: Adjustments
If ignition switch cannot be turned to the LOCK position, with shifter in PARK, an adjustment of the Interlock System may be required. To adjust
Shifter/Ignition Interlock System. follow procedure listed below.
1. Disconnect and isolate, the battery negative (-) cable from the vehicle battery.
2. Remove console assembly.
3. Remove the gearshift knob set screw and knob.
4. Remove the screws retaining the gearshift indicator bezel and remove bezel and indicator lamp.
5. Reinstall the gearshift knob.
6. Place shifter in PARK.
7. Turn ignition switch to the LOCK or ACCESSORY position. If cable has lost its adjustment, manually position cable to get key into LOCK or
ACCESSORY position. Grasp slug on interlock cable with needle-nose pliers and pull back on cable. This will allow the ignition switch to be
turned to the LOCK or ACCESSORY position.
8. Check that the interlock cable slug is completely seated into the shifter interlock lever.
9. Check that the ignition switch is still in the LOCK or ACCESSORY position.
10. Pry up the adjuster lock on the shifter/ignition interlock cable.
