Grand Voyager V6-3.3L VIN G Flex Fuel (1999)
Master Cylinder To Fluid Reservoir Seal Grommets
6. Remove the 2 master cylinder housing to brake fluid reservoir seal grommets.
7. Install new master cylinder housing to brake fluid reservoir sealing grommets in master cylinder housing.
8. Lubricate reservoir mounting area with fresh clean brake fluid. Place reservoir in position over sealing grommets. Seat reservoir into sealing
grommets using a rocking motion while firmly pressing down on fluid reservoir.
9. Be sure fluid reservoir is positioned properly on master cylinder. Bottom of fluid reservoir is to be touching the top of both sealing grommets when
properly installed on master cylinder housing.
10. Install the 2 fluid reservoir to master cylinder retaining pins.
11. Install the master cylinder assembly on the power brake vacuum booster.
12. Install filler tube on the fluid reservoir. Fill fluid reservoir to its proper level as indicated on the outboard side of the fluid reservoir. Be careful not
to overfill the fluid reservoir, fluid is not intended to be stored in the filler tube. Install cap on fluid reservoir filler tube.
