Grand Voyager V6-3.3L VIN G Flex Fuel (1999)
17. Connect vacuum harness to throttle body.
18. Install the direct ignition system (DIS) coils. Tighten fasteners to 12 Nm (105 in. lbs.) torque.
19. Install fuel hose quick connector fitting to chassis tubes. Refer to Fuel Hoses, Clamps and Quick Connect Fittings. Push the fitting onto the chassis
tube until it clicks into place. Pull on the fitting to ensure complete insertion.
20. Install throttle cable and speed control cable (if equipped).
21. Install air inlet resonator.
22. Connect negative cable to battery.
CAUTION: When using the ASD Fuel System Test, the ASD relay and fuel pump relay remain energized for 7 minutes or until the test is
stopped, or until the ignition switch is turned to the Off position.
23. With the ignition key in ON position, access the DRB scan tool ASD Fuel System Test to pressurize the fuel system. Check for leaks.
