Grand Voyager V6-3.8L VIN L (1999)
System initialization is accomplished by:
1. Opening the hood to ensure the hood ajar circuit is closed.
1. Rotating the key in liftgate cylinder to unlock/disarm position.
Arming/Disarming- Active arming occurs when the remote keyless entry transmitter is used to lock the vehicle doors, whether the doors are open
or closed. If one or more doors are open, the arming sequence is completed only after all door are closed.
Passive disarming occurs upon normal vehicle entry (unlocking either front door or the liftgate with the key). This disarming also will halt the
alarm once it has been activated.
Active disarming occurs when the remote keyless entry transmitter is used to unlock the vehicle doors. This disarming also will halt the alarm once
it has been activated.
System Self-Test - NOTE: System self-test can be entered only with the DRB.
NOTE: A POWERTRAIN CONTROL MODULE FROM A VEHICLE EQUIPPED WITH A VEHICLE THEFT SECURITY SYSTEM
CANNOT BE USED IN A VEHICLE THAT IS NOT EQUIPPED WITH A VEHICLE THEFT SECURITY SYSTEM.
If the VTSS indicator lamp comes on after ignition ON and stays on, the CCD bus communication with the powertrain control module possibly has
been lost.
WIPER SYSTEM
Front
The front wiper system provide the driver with normal wipe (low and high speeds), intermittent wipe, wipe after wash, and pulse wipe
functions. The driver selects the wiper function via a resistive multiplexed stalk switch mounted on the steering column. When the wiper is in
the on position and the ignition is turned OFF the wiper will continue to run until it reaches its park position.
Other front wiper system features:
Speed Sensitive Intermittent Wipe Mode- There are 6 individual delay times with minimum delay of 1/2 second to a maximum of 18
seconds. When the vehicle speed is under 10 MPH, the delay time is doubled to provide a range time of from 1 second to 36 seconds.
Pulse Wipe - When the wiper is in the off position and the driver presses the wash button for more than 62 msec but less than 1/2 second, 1
wipe cycle in low speed mode will be provided.
Wipe After Wash Mode - When the driver presses the wash button for over 1/2 second and then releases it, the wiper will continue to run for
2 additional wipe cycles.
Rear
The rear wiper system provides the driver with continuous, intermittent, and wiper after wash functions. The driver selects the wiper function
via a resistive multiplexed switch mounted in the HVAC control.
DRB III (R) ERROR MESSAGES
Under normal operation, the DRB will display one of only two error messages:
- User-Requested WARM Boot or User- Requested COLD Boot
If the DRB should display any other error message, record the entire display and call the MDS Hotline, or call for information and assistance at
1-800-825-8737. This is a sample of such an error message display:
ver: 2.14
date: 26 Jul93
file: keyitf.cc
date: Jul 26 1993 line: 548
err: Ox1
User-Requested COLD Boot
Press MORE to switch between this display and the application screen.
Press F4 when done noting information.
DRB III (R) Does Not Power UP (Blank Screen)
If the LED's do not light or no sound is emitted at start up, check for loose cable connections or a bad cable. Check the vehicle battery voltage
(data link connector cavity 16). A minimum of 11 volts is required to adequately power the DRB.
If all connections are proper between the DRB and the vehicle or other devices, and the vehicle battery is fully charged, an inoperative DRB may
be the result of faulty cable or vehicle wiring. Perform Vehicle Communication TEST 1A.
