Horizon L4-135 2.2L SOHC VIN C (1988)
Fig. 7 Jounce bumper, dust shield & lower spring seat replacement
SERVICE
1. Install coil spring retractors, tool L-4514, or equivalent, on coil spring and support in a vise. Grip 4 or 5 coils of the spring in the retractors. Also,
do not extend retractors more than 91-4 inches.
2. Tighten retractors evenly until spring pressure is released from upper spring seat.
3. Hold flat end of pushrod and loosen retaining nut. Ensure that spring is properly compressed before loosening retaining nut since personal
injury may result.
4. Remove lower isolator, pushrod sleeve and upper spring seat.
5. Remove shock absorber from coil spring.
6. Remove jounce bumper and dust shield from pushrod.
7. Remove lower spring seat.
8. Reverse procedure to assemble.
