Laser FWD L4-1997cc 2.0L DOHC (1992)
3.
Install shim kit part number MR128416 to both inner and outer pads as shown in Figure 1. The slotted shim is placed against the brake pad
backing plate (tabs up), and the stainless steel shim is placed on top of the coated shim (tabs down). Apply a small amount of grease between the
pad backing plate and slotted shim, and again between the slotted shim and stainless steel shim.
4.
Re-assemble the rear brakes and road test the vehicle to verify squeak elimination.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No.
05-70-22-95
0.9 Hrs.
FAILURE CODE: 68 - Noisy
