Laser FWD L4-1997cc 2.0L DOHC (1992)
All involved vehicle owners known to Chrysler are being notified of the service requirement by first class mail. They are requested to schedule
appointments for the service with their dealers at the earliest possible date. A copy of the owner notification letter is included.
Enclosed with each owner notification is an Owner Recall Notification Form. The involved vehicle and recall are identified on the form for owner or
dealer reference as needed.
Service Procedure
A.
Replace Oxygen Sensor
1.
Disconnect the oxygen sensor electrical connector (Figure 1).
2.
Apply Mopar Rust Penetrant PN 4318039 (or equivalent) to the oxygen sensor to ease removal.
3.
Using special tool MD998748 and an offset box-end wrench, remove the oxygen sensor (Figure 2).
4.
Install the supplied oxygen sensor using the special tool. Torque to 33 ftlbs (45 N-m).
5.
Connect the oxygen sensor electrical connector.
6.
Disconnect the battery negative cable for more than ten seconds to erase any diagnostic codes.
7.
Reconnect the battery negative cable.
B.
Install Recall Completion Label
1.
With a ball point pen, print your dealer code (5 digits) on the supplied Recall Completion Label.
2.
Peel the label from its backing and apply it near the Vehicle Emission Control Information Label.
