Laser FWD L4-1997cc 2.0L DOHC (1992)
Fig. 11 Removing Stabilizer Bar (FWD Models). Pillow-ball Type
2 WHEEL DRIVE
Remove stabilizer bar in numbered sequence, noting the following:
1. Front exhaust pipe must be removed.
2. Pull both ends of stabilizer bar to rear of driveshaft.
3. Move right side of bar until it clears lower arm.
4. Pull stabilizer bar out right side.
5. Check stabilizer bar ball joint starting torque; starting torque should be 15-28 lb-in. If starting torque is outside of specified torque, replace
stabilizer link.
6. Reverse procedure to install.
