Laser FWD L4-1997cc 2.0L DOHC Turbo (1993)
Note: Be sure to install the throttle body gasket as shown. Incorrect installation may result in poor idle quality.
Installation
1. Install a new gasket.
2. Install the throttle body and torque the bolts, in a cross-pattern.
Torque value:
11 - 16 ft lb (15 - 22 N-m)
Throttle Body Attachment Bolts
Note: Bolts #1 and #2 are not the same length, ensure that the bolt installed in #1 is .31 x 1.18 in. (8 x 30 mm) and the bolt in #2 is .31 x 2.16 in.
(8 x 30 mm).
3. Install the throttle body stay, torque the bolts.
Torque value:
7 - 9 ft lb (10 - 13 N-m)
4. Reconnect the throttle cable (and cruise control cable, if equipped).
5. Reconnect the intake air duct.
6. For the initial adjustment of the throttle position sensor and the idle speed screw, refer to ADJUSTMENT PROCEDURES.
