Laser FWD L4-1997cc 2.0L DOHC Turbo (1993)
Continuity should exist, while the battery is connected.
Testing The Power Transistor
4. Connect the positive lead of the ohmmeter to terminal # 3, and the negative lead of the ohmmeter to terminal # 1.
Continuity should NOT exist.
5. Connect the positive lead of a 1.5 volt battery to terminal # 2 and the negative lead of the battery to terminal # 3.
Continuity should exist, while the battery is connected.
Power Transistor & Ignition Coil
Ignition Coil And Power Transistor Circuit
Note: To test the Power Transistor / Ignition Coil use an analog type circuit tester and proceed as follows:
COMPONENT TEST
Note: The circuit tester used in the following test procedures should be an analog type.
1. Disconnect the electrical connector to the Power Transistor.
