Testing and Inspection of Seat Belt Buckle Switch for Laser FWD L4-1997cc 20L Turbo
i.
With shoulder belt pulled half way out to fully pulled out position (outer switch On), continuity should be indicated.
j.
If resistance indicated is as specified, circuit is satisfactory. Proceed to step l.
k. If resistance indicated is not as specified, replace shoulder belt retractor assembly.
l.
Connect shoulder belt to slide anchor (outer switch On). Connect outer switch harness connector, then disconnect control unit harness
connector.
m. Connect ohmmeter between control unit connector terminal 3 and ground, then terminal 14 and ground.
n. Ohmmeter should indicate continuity.
o. If continuity is indicated, circuit is satisfactory.
p. If continuity is not indicated, repair harness as necessary.
