Laser FWD L4-1997cc 2.0L DOHC Turbo (1993)
Ball Stud: Service and Repair
Fig. 1 Removing Hub & Knuckle Assembly
REMOVAL
NOTE: Remove knuckle and hub assembly in numbered sequence, noting the following:
1. Loosen driveshaft nut with vehicle on floor and brakes applied.
2. Remove speed sensor mounting bolts, then the sensor.
CAUTION: Use care not to damage pole piece at tip of speed sensor and the toothed edge of the rotor.
3. Remove and suspend caliper assembly using a piece of wire.
Fig. 2 Removing Driveshaft
4. Insert pry bar between transaxle case and driveshaft, then pry driveshaft from transaxle.
CAUTION: Do not pull on driveshaft.