Neon L4-2.0L DOHC (1996)
Thermostat: Service and Repair
REMOVAL
1. Drain cooling system to the thermostat level or below.
2. Remove Coolant Recovery System (CRS) hose and thermostat/engine outlet connector bolts.
3. Remove thermostat assembly, and clean sealing surfaces.
INSTALLATION
1. Place the new thermostat assembly into the engine outlet connector. Align air bleed with notch on the cylinder head.
2. Install thermostat housing/outlet connector onto cylinder head and tighten bolts to 12.5 Nm (110 inch lbs.). Connect the CRS hose.
3. Refill cooling system.
