Neon L4-2.0L DOHC (1996)
Control Assembly: Service and Repair
HEATER A/C CONTROL
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Using a trim stick (special tool #C-4755), gently pry up on the top cover and cluster bezel to remove.
3. Open the ash receiver.
4. Using a trim stick (special tool #C-4755), gently Pry out on the center bezel and remove.
5. Remove the six attaching screws across the forward portion of the right upper trim panel. Then pull the panel rearward to disengage the three
locator pins and remove.
