Neon L4-2.0L DOHC (1996)
Air Bag Control Module: Service and Repair
WARNING: The ACM contains a safing sensor which enables the system to deploy the airbags. To avoid accidental deployment, never connect
ACM electrically to the system while vehicle battery is connected. Disconnect and isolate the battery negative (ground) cable before beginning
any airbag system component removal or installation procedure. This will disable the airbag system. Failure to disconnect battery could result
in accidental airbag deployment and possible personal injury. Allow system capacitor to discharge for 2 minutes before removing any airbag
components.
CAUTION: Failure to follow the parking brake service procedures can result in damage to the parking brake mechanism.
WARNING: The auto adjusting feature of this parking brake lever assembly contains a clock spring loaded to approximately 20 pounds. DO
NOT release the auto adjuster lockout device before installing cables into the equalizer. Keep hands out of auto adjuster sector and pawl area.
Failure to observe caution in handling this mechanism could lead to serious injury.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Manual transaxle only, remove shifter knob fastener and remove shifter knob.
Fig 6 Attaching Screws At Rear Of Center Console With/Without Arm Rest
Fig 7 Attaching Screws At Rear Of Center Console With Arm Rest
3. Remove screws attaching rear of center console assembly to console bracket.
