Neon L4-2.0L DOHC (1996)
Impact Sensor: Service and Repair
Left Impact Sensor
Fig. 7 Remove Or Install Battery Cable
WARNING: Before beginning any airbag system component removal or installation procedures, disconnect and isolate the battery negative
(ground) cable. This will disable the airbag system. Failure to do this could result in accidental airbag deployment and possible personal injury.
1. Remove battery negative cable and battery positive cable in this order.
2. Remove battery thermoguard.
3. Remove battery hold down clamp and battery from vehicle.
4. Remove battery tray and air inlet hose.
Fig. 10 Impact Sensor Location
5. Remove sensor and disconnect impact sensor electrical connector.
Fig. 11 Impact Sensor