Neon L4-2.0L DOHC (1996)
12. Separate ball joint stud from steering knuckle by prying down on lower control arm.
NOTE: Care must be taken not to separate the inner ON joint during this operation. Do not allow driveshaft to hang by inner ON joint, driveshaft
must be supported.
13. Pull steering knuckle assembly out and away from outer C/V joint of the driveshaft assembly.
14. Support outer end of the driveshaft assembly.
NOTE: Removal of the inner tripod joints is made easier if you apply outward pressure on the joint as you strike the punch with a hammer.
