plymouth Workshop Repair Guides

Plymouth Workshop Service and Repair Manuals

Recall - Brake/Fuel Tube Corrosion|Page 7061 > < Recall - Brake/Fuel Tube Corrosion|Page 7059
Page 3
background image

800 Chrysler Drive East
Auburn Hills, Michigan 48326-2757

Following the above procedures will expedite the processing of your claim.

If you have any questions or need assistance in completing this action, please contact your Zone Service Office.

A. Inspect Tubes For Corrosion and Install Retaining Clip

1.

With ignition switch in the off position, raise vehicle on a hoist.

2.

Remove and discard the under body bracket and rubber isolator retaining the rear brake tubes, fuel vapor tube and fuel supply tube (Figure 1).

3.

Carefully inspect all four tubes in the area that was covered by the rubber isolator as shown in figure 2. If any one of the four tubes have any RED
CORROSION, the tube(s) must be replaced. Proceed to section B. Replace Corroded Tube(s) and Install Retaining Clip". Tubes with white
powder or other residue/discoloration do not require replacement.

Recall - Brake/Fuel Tube Corrosion|Page 7061 > < Recall - Brake/Fuel Tube Corrosion|Page 7059