Neon L4-2.0L SOHC (1995)
3.
Disconnect the primary and secondary brake tubes from master cylinder housing (Figure 3). Install plugs at both open brake tube outlets.
Note:
Clean brake tube connections and master cylinder to booster area with a suitable brake cleaner before disconnecting tubes.
4.
Remove the 2 nuts attaching the master cylinder to the power brake vacuum booster and slide the master cylinder straight out of the booster
(Figure 4).
5.
Remove the vacuum seal located in the front of the power brake vacuum booster by carefully inserting a small screw driver between the push rod
of the power brake vacuum booster and vacuum seal. Then pry seal out of the booster (Figure 5).
Caution:
Do NOT attempt to pry seal out of power brake vacuum booster by inserting a tool between the seal and the brake booster.
