Neon L4-2.0L SOHC (1995)
5. Reverse procedure for installation. Before tightening the thru-bolt be sure there is no load in the insulator. Tighten the thru bolt to 108 Nm (80 ft.
lbs.).
RIGHT
1. Remove purge duty solenoid from engine mount bracket.
2. Remove right engine mount insulator vertical fasteners from frame rail.
3. Carefully support engine/transaxle assembly to relieve pressure on mount.
4. Remove through bolt from insulator, then the insulator.
5. Reverse removal procedure for installtion. Tighten the engine mount to frame rail fasteners to 54 Nm (40 ft. lbs.) Before tightening the thru-bolt
be sure there is no load on the insulator. Tighten the thru-bolt to 108 Nm (80 ft. lbs.).
