Neon L4-2.0L SOHC (1995)
B) Apply one drop of Lock N' Seal to the new mounting screw, P/N 6501714.
C) Install new mounting screw.
IMPORTANT:
TIGHTEN THE ATTACHING SCREW TO 60 IN. LBS. AND THEN BACK THE SCREW OFF 1 FULL TURN. FOLLOW THIS PROCEDURE
ANY TIME A VEHICLE SPEED SENSOR IS INSTALLED.
4.
Install the vehicle speed sensor wire harness connector.
5.
Repeat the diagnostic procedure to confirm that the vehicle speed sensor is functioning properly.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
08-45-13-95..........................................................................................................................................................................0.3 Hrs.
FAILURE CODE:
P8 - New Part
