Neon L4-2.0L SOHC (1995)
1.
With the lower steering column shroud off the vehicle, remove approximately .040" (1 mm) of material from the upper inside diameter of the key
lock cylinder opening. Use a rattail file, utility knife or tapered reamer to remove the necessary material. See Illustration.
2.
Install the lower column shroud on the column and secure in place with the three screws. Install the key lock cylinder in place.
3.
Verify that the switch returns to the run position after starting and all electrical components are functioning properly. If not, additional material
will have to be removed from the lower column shroud.
4.
Install the steering column cover liner back on the vehicle.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
19-20-36-91
0.3 Hrs.
FAILURE CODE: XX - Service Adjustment
