Neon L4-2.0L SOHC (1995)
PARTS REQUIRED:
AR
4874430
Throttle Position Sensor, SOHC (PL, JA)
AR
4874431
Throttle Position Sensor, DOHC (PL, JA)
AR
4874430
Throttle Position Sensor, SOHC or DOHC (FJ)
REPAIR PROCEDURE:
This bulletin involves the replacement of the throttle position sensor and 0-ring, or the replacement of the throttle body.
THROTTLE POSITION SENSOR REPLACEMENT:
1.
Remove throttle position sensor from the throttle body by removing the two attaching screws. The attaching screws should be discarded.
Replacement screws will be provided with the new throttle position sensor.
2.
Remove the 0-ring from the throttle body casting and discard.
3.
Lubricate the new 0-ring provided with the new throttle position sensor. Apply one to three drops of a light grade of vegetable oil and allow excess
to drain off.
CAUTION:
DO NOT USE ENGINE OIL, IT WILL NOT PROPERLY LUBRICATE THE 0-RING.
4.
Install the 0-ring into the groove in the throttle body.
CAUTION:
DO NOT INSTALL THE 0-RING ONTO THE NOSE PILOT OF THE THROTTLE POSITION SENSOR OR DAMAGE MAY OCCUR.
5.
Install the throttle position sensor and attachment screws as outlined in the appropriate service manual under group 14, throttle position sensor
installation.
THROTTLE BODY REPLACEMENT:
1.
To replace the throttle body refer to the appropriate service manual in group 14, throttle body removal and installation.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No.: 14-30-02-94
0.4 Hrs.
Throttle Body - Replace (JA, FJ)
14-30-02-95
0.5 Hrs.
Throttle Body - Replace (PL)
08-14-10-97
0.3 Hrs.
Sensor, Throttle Position - Replace (JA, FJ
Sebring)
08-14-10-98
0.6 Hrs.
Sensor, Throttle Position - Replace (PL)
08-14-10-99
0.2 Hrs.
Sensor, Throttle Position - Replace (FJ Talon)
FAILURE CODE:
P8 - New Part
