Neon L4-2.0L SOHC (1995)
Do not apply shop air pressure directly into the throttle shaft and throttle body housing holes.
5.
Open and close the throttle blade on the throttle body to verify that there is no increased effort when moving from the closed position. If the
condition is corrected, proceed to the next step. If the effort still exists, then some other condition exists with the throttle body and/or linkage and
further diagnosis and repair will be necessary and will not be covered by this repair procedure.
6.
Install the throttle body back on the engine.
NOTE:
The Mopar Diagnostic System (MDS) is required to perform the following repair and the system must be operating with release 18 or higher and TIL
CD release 1095 or higher must be installed.
REPAIR PROCEDURE (B):
This repair involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software (calibrations) which disables the
EGR system below 10° F.
1.
Connect the MDS (Mopar Diagnostic System) and DRB III (Scan Tool) to the vehicle and power them up.
2.
Use the arrow keys and select # 2 MDS DIAGNOSTICS on the DRB III MAIN MENU Screen.
3.
Use the arrow keys and select DIAGNOSTIC MENU on the MDS, then press NEXT MENU.
4.
Use the arrow keys and select CONTROLLER PROGRAMMING on the MDS, then press NEXT MENU.
5.
Use the arrow keys and select PROGRAM CONTROLLER PART on the MDS, then press NEXT MENU.
6.
Follow the steps presented on the MDS and DRB III which will allow the DRB III to obtain the current part number of the PCM.
7.
The MDS will display the part number of the PCM on the vehicle and the appropriate replacement part number, then press NEXT MENU to begin
programming. If the PCM on the vehicle has already been updated or programmed, a NO UPDATES AVAILABLE message will be displayed.
Check the part number of the PCM on the vehicle and compare it to the part number displayed. If the PCM has already been updated, then another
condition exists that will require further diagnosis and repair.
8.
The MDS and DRB III will prompt for any operator action needed during the remainder of the programming process.
NOTE:
The following steps are required by law.
9.
Type the necessary information on the "Authorized Software Update Label" and attach it to the PCM and cover the label with a clear plastic
sticker.
10.
Type the necessary information on the Authorized Modification Label and attach the label near the VECI Label.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Throttle Body, Remove and Clean
Labor Operation No:
14-30-02-93 ....................................................................................................................................................................... 0.6 Hrs.
Remove and Clean
1995 PL
Residue from Throttle Body
