Neon L4-2.0L SOHC (1995)
3.
Depress two release tabs at front of Power Distribution Center (PDC) and set PDC aside for access to Powertrain Control Module (PCM) and
wiring (Figure 2).
4.
Disconnect PCM 60-way wiring connector.
5.
Remove the three PCM mounting screws, disconnect wiring take-out clip and remove PCM with bracket assembly (Figure 3).
6.
Route excess 60-way PCM wiring under the front engine compartment wiring harness so that the 60- way wiring forms a downward loop from the
PCM (Figure 4).
7.
Install the PCM 60-way wiring connector onto the new PCM assembly and torque bolt to 35 lb-in. (New PCM installation bracket positions
60-way connector so that it faces rearward).
8.
Install the two provided screws into the rear PCM bracket mounting holes and tighten securely.
9.
Center punch and drill an 1/8 inch hole in sheet metal at the forward PCM bracket hole location, then coat exposed metal with primer. Install one
of the old (pointed) mounting screws in the drilled hole and tighten securely (Figure 5).
Caution:
