Neon L4-2.0L SOHC (1995)
scan tool to test the camshaft position sensor and sensor circuits. Refer to the electrical diagrams for circuit information.
b. If the test light did not flash during cranking, unplug the camshaft position sensor connector. Turn the ignition key to the OFF position. Turn
the key to the ON position, wait for the test light to momentarily flash once, then crank the engine.
-
If the test light momentarily flashes, the camshaft position sensor is shorted and must be replaced.
-
If the light did not flash when the engine was cranked, the cause of the no-start is in either the crankshaft position sensor/camshaft position
sensor 8-volt supply circuit, or the crankshaft position sensor 5-volt output or ground circuits. Use the DRB or equivalent scan tool to test the
crankshaft position sensor and the sensor circuits. Refer to the electrical diagrams for circuit information.
