Neon L4-2.0L SOHC (1995)
Technical Service Bulletin # 180697A
Date: 970307
PCM/Battery Cable - Slow Start/MIL ON/DTC #19 Set
NO: 18-06-97 Rev. A
GROUP: Vehicle Performance
DATE: Mar. 7, 1997
SUBJECT:
Engine Slow Crank/MIL Illuminated - IAC DTC Hex **$19** Set
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 18-06-97, DATED FEB. 14, 1997 WHICH SHOULD BE REMOVED FROM
YOUR FILES. ALL REVISIONS ARE HIGHLIGHTED WITH **ASTERISKS** AND INCLUDE CORRECTION OF THE "HEX CODE".
MODELS:
1995 (PL) Neon
SYMPTOM/CONDITION:
Engine will slowly crank and then start, immediately after starting the malfunction indicator light (MIL) will illuminate. When checked the "Idle Air
Control(IAC)" will be set.
DIAGNOSIS:
Using the Mopar Diagnostic System (MDS) or the Diagnostic Scan Tool (DRB III) with the appropriate Diagnostic Procedures Manual, verify all
engine/transmission systems are functioning as designed. If Diagnostic Trouble Codes (DTC's) other than any IAC related codes are present, record them
on the repair order and repair as necessary before proceeding further with this bulletin. If the DTC for "Idle Air Control" Hex **$19** is found clear the
code and perform the Repair Procedure.
NOTE:
VEHICLES BUILT PRIOR TO AUGUST 1, 1994 (MDH 08-01-XX) MUST HAVE THE POWERTRAIN CONTROL MODULE (PCM)
REPLACED BEFORE PROCEEDING WITH THIS REPAIR.
PARTS REQUIRED:
AR
04874154
Powertrain Control Module (2.0L MPI-FED-LOW ALT.- M/T)
AR
04874155
Powertrain Control Module (2.0L MPI-FED-HIGH ALT. & CAL-M/T)
AR
04874156
Powertrain Control Module (2.0L MPI-FED-LOW ALT.- 3ATX)
AR
04874157
Powertrain Control Module (2.0L MPI-FED & CAL- M/T)(ACR)
AR
04874158
Powertrain Control Module (2.0L MPI-FED-HIGH ALT. & CAL -3ATX)
1
04796440
Cable, Positive Battery Kit
EQUIPMENT REQUIRED:
1
CH6000
Scan Tool (DRB III)
1
CH7035
General Purpose Interface Bus Gable (GPIB)
1
CH7000/7001 J1962 Cable
1
4669020
Label - Authorized Software Update
1
4275086
Label - Authorized Modification
NOTE:
THE MDS AND DRBIII ARE REQUIRED TO PERFORM THIS REPAIR AND THE SYSTEM MUST BE OPERATING WITH RELEASE 21
OR HIGHER AND TIL CD RELEASE 1125 OR HIGHER MUST BE INSTALLED.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
08-19-47-95
0.5 Hrs.
Module, Powertrain
Control - Reprogram
08-19-47-96
0.8 Hrs.
Module, Powertrain
Control - Replace
