Neon L4-2.0L SOHC (1995)
To avoid drilling into the windshield washer bottle, tape drill bit 1/4 inch from the end.
10.
Reinstall PDC and lock two release tabs in place.
11.
Reinstall positive, then negative battery terminals.
VECI LABEL INSPECTION AND INSTALLATION:
12.
Inspect the part number of the VECI label mounted on the under-side of the hood and install a new label over the existing one ONLY AS
DIRECTED (see illustration).
ADDENDUM TO SAFETY RECALL # 614
Models:
1995 Modal Year Plymouth/Dodge Neon (PL) Vehicles Built Through February 1, 1994, (MDH 02-01-XX).
Service Requirement Summary:
REPLACEMENT OF REAR BRAKE FLEX HOSE MOUNTING BRACKET SCREWS
NOTE:
THERE ARE SIX SCREWS INCLUDED IN THIS PARTS PACKAGE, ONLY FOUR ARE TO BE USED FOR THE BRAKE FLEX HOSE
MOUNTING BRACKET PROCEDURE, AND TWO ARE TO BE USED FOR THE INSTALLATION OF THE PCM MOUNTING BRACKET.
1.
Locate the brake flex hose mounting bracket attached to the frame. (See Illustration).
2.
Remove and replace the two screws on both sides of the vehicle. Replace them with four of the six screws provided in the parts package. Torque
the new screws to 105 +/- 20 in.lbs. (12 +/- 2 N-m).
