Neon L4-2.0L SOHC (1995)
5. Remove lateral link to knuckle bolt, then using a suitable adjustable wrench to prevent tension strut from turning, remove tension strut nut, washer
and bushing.
6. Remove spindle knuckle to strut clevis bolts that were previously loosened, then pull spindle knuckle straight out of strut and rotate off tension
strut.
7. Reverse procedure to install, noting the following:
a. Tighten bolts and nuts to specifications.
b. When tightening spindle knuckle to strut clevis bolts, do not turn bolts. Tighten by turning nuts only.
c. The lateral link to spindle knuckle bolt must be installed with head of bolt towards front of vehicle.
d. Lateral link bolts must be tightened to specifications with suspension supporting vehicle weight.
Tension Strut Bushings
e. Refer to image when installing tension strut retainer washers and bushings.
f.
Check and adjust rear wheel alignment as outlined under Steering and Suspension / Alignment / Adjustments.
