Neon L4-2.0L VIN C (1997)
7. Using a hammer and Installer Piston Caliper Boot, Special Tool C-4689 and Handle, Special Tool C-4171, or equivalent, drive boot into
counterbore of the caliper.
8. Install guide pin sleeves and bushings. Refer to Guide Pin Installation.
9. Install brake pads. Refer to Disc Brake Pad Installation.
10. Before installing caliper assembly on vehicle, inspect brake rotor. If any conditions as described in Checking Brake Rotor for Runout and
Thickness are present the rotor, must be replaced or refaced. If the rotor does not require any servicing, install caliper assembly.
11. Install brake hose onto caliper using banjo bolt. Torque the brake hose to caliper assembly banjo bolt to 33 Nm (24 ft. lbs). New seal washers
MUST always be used when installing brake hose to caliper.
12. Bleed the brake system.
Removal
GENERAL INFORMATION
The double pin caliper uses a sealed for life bushing and sleeve assembly If required this assembly can be serviced using the following procedure.
PROCEDURE
1. Remove caliper from brake rotor. Hang caliper assembly on a wire hook away from the brake rotor.