Neon L4-2.0L VIN C (1997)
vacuum seal onto master push rod until seal is seated against master cylinder housing before installing master cylinder on power brake vacuum
booster.
CAUTION: If vehicle is equipped with ABS, be sure old vacuum seal is removed from power brake vacuum booster before attempting to install
master cylinder and NEW vacuum seal. If vacuum seal is not removed, refer to Master Cylinder Removal in this section of the service manual for
required vacuum seal removal procedure.
3. Position master cylinder on studs of power brake unit, aligning push rod on power brake vacuum booster with master cylinder push rod.
Master Cylinder Mounting To Vacuum Booster
4. Install the 2 master cylinder to power brake unit mounting nuts and torque to 28 Nm (250 in. lbs.).
Fig 7 Type 3 Primary And Secondary Output Ports. With ABS
5. Connect brake tubes to master cylinder primary and secondary ports. Torque all tube nuts to 17 Nm (145 in. lbs.).
