Neon L4-2.0L VIN C (1997)
Fig 20 Type 3 Vacuum Seal Seating. Neon Models Equipped With ABS
13. Install vacuum seal on master cylinder push rod as shown with notches on vacuum seal pointing toward master cylinder housing. Then slide
vacuum seal onto master push rod until seal is seated against master cylinder housing before installing master cylinder on power brake vacuum
booster.
CAUTION: If vehicle is equipped with ABS, be sure old vacuum seal is removed from power brake vacuum booster before attempting to install
master cylinder and NEW vacuum seal. If vacuum seal is not removed, refer to Brakes, Master Cylinder Service and Repair for required vacuum
seal removal procedure.
14. Position master cylinder on studs of power brake unit, aligning push rod on power brake vacuum booster with master cylinder push rod.
Master Cylinder Mounting To Vacuum Booster
15. Install the 2 master cylinder to power brake unit mounting nuts and torque to 28 Nm (250 inch lbs.).
Fig 7 Type 3 Primary And Secondary Output Ports. With ABS
16. Connect brake tubes to master cylinder primary and secondary ports. Torque all tube nuts to 17 Nm (145 inch lbs.).
