Neon L4-2.0L VIN C (1997)
Pump Motor To Relay Box Electrical Seal
1.
Be sure electrical connector seal is installed in pump motor housing before installing relay box. If electrical connector seal is cracked, brittle
or in any way damaged it must be replaced before installing relay box.
2.
Position relay box on HCU and carefully align the terminals on the relay box with the terminals on the pump motor.
3.
Grasp relay box with both hands. Then without twisting or rocking, push relay box onto the pump motor electrical connector as far as
possible by hand.
4.
Install and securely tighten the 2 screws attaching the relay box assembly to the HCU.
5.
Reconnect the 6 way connector onto the relay box.
6.
Install the HCU back in the vehicle. Refer to Hydraulic Control Unit Installation, for the required HCU installation procedure.
7.
Connect the negative (-) ground cable back on the negative post of the battery.
8.
Bleed the base brakes and the ABS brakes hydraulic systems. Refer to Brakes Service and Repair and Antilock Brake System Service and
Repair for the required procedures.
9.
Road test vehicle to ensure proper operation of the base and ABS systems.
