Neon L4-2.0L VIN C (1997)
Parking Brake Shoe Assemblies
Parking Brake Actuator Lever
5. On vehicles equipped with rear disc brakes, install park brake shoes actuator lever on park brake cable. Then install park brake shoe assemblies on
disc brake adapter.
6. Install the hub/bearing assembly on the rear spindle. Then install A NEW rear hub/bearing assembly retaining nut. Torque hub/bearing assembly
retaining nut to 217 Nm (160 ft. lbs.).
7. Install hub/bearing assembly dust cap, using a soft faced hammer.
8. On drum brake equipped vehicles, install rear brake drum on hub/bearing assembly. On vehicles equipped with rear disc brakes, install rotor on
hub/ bearing assembly.
Rear Caliper Guide Pin Bolts
9. On disc brake equipped vehicles install disc brake caliper on disc brake adapter. Install the 2 caliper guide pin bolts and torque to 22 Nm (192 in.
lbs.). Refer to Disc Brake Caliper Service and Repair for installation procedure.
10. Install rear wheel and tire assembly on vehicle, tighten all wheel stud nuts in crisscross pattern to one-half specified torque. Then repeat pattern,
fully tightening stud nuts to 109 - 150 Nm (80 - 110 ft. lbs.).
