Neon L4-2.0L VIN C (1997)
PROCEDURE
1. Remove the screws attaching the rear of the center console assembly to console bracket.
Attaching Screws At Front Of Center Console
2. Remove the 2 screws located in cup holders, attaching front of center console assembly to console bracket.
3. Raise park brake hand lever as high as it will go to get the required clearance to remove the center console.
4. Remove center console assembly.
WARNING: WHEN REPAIRS TO THE PARK BRAKE HAND LEVER ASSEMBLY OR CABLES IS REQUIRED, THE AUTO
ADJUSTER MUST BE RELOADED AND LOCKED OUT.
5. Lower park brake lever handle.
Locking Pin Installed In Park Brake Lever
6. Grasp park brake lever output cable by hand and pull rearward. Continue pulling on cable until a 3/16 in. drill bit can be inserted into handle and
sector gear of park brake mechanism. This will lock the park brake mechanism and take tension off park brake cables.
