Neon L4-2.0L VIN C (1997)
4. Remove power steering pressure hose from routing clip on generator shield.
5. Lower vehicle.
6. Remove bolt, attaching power steering pressure hose routing clip, to generator shield.
7. Loosen and remove Banjo bolt, and power steering pressure hose from pressure fitting on power steering pump.
8. Power steering fluid pressure hose is removed from the vehicle from the top of the engine compartment.
9. Discard all used O-rings located at ends of power steering pressure hose and Banjo bolt.
Installation
1. Install power steering pressure hose in vehicle from top of engine compartment.
2. Using a lint free towel, wipe clean all open power steering hose ends, and the power steering pump and steering gear ports.
3. Install new O-ring on end of power steering pressure hose banjo fitting.
