Neon L4-2.0L VIN C (1997)
4. Install a new O-ring on power steering pressure hose banjo fitting bolt.
5. Lubricate both O-rings using fresh clean power steering fluid.
6. Install banjo bolt into the power steering pressure hose banjo fitting.
7. Attach power steering pressure hose to outlet fitting on power steering pump. Do not tighten or torque pressure fitting Banjo bolt at this time.
8. Correctly route power steering pressure hose avoiding tight bends or kinking of the hose. Install power steering pressure hose to generator shield
routing clip attaching screw but do not tighten at this time.
9. Raise vehicle.
CAUTION: Hoses must remain away from exhaust system, vehicle components and unfriendly surfaces causing possible damage to power
steering hoses.
