Neon L4-2.0L VIN C (1997)
Knock Sensor: Service and Repair
Fig. 16 Knock Sensor
NOTE: The knock sensor threads into the side of the cylinder block in front of the starter (Fig. 16).
REMOVAL
1. Disconnect electrical connector from knock sensor.
2. Use a crow foot socket to remove the knock sensors.
INSTALLATION
1. Install knock sensor. Tighten knock sensor to 10 Nm (7 ft lb) torque.
CAUTION: Over or under tightening effects knock sensor performance, possibly causing improper spark control.
2. Attach electrical connector to knock sensor.
